Contributed by
Keith Adams, STOC #8824.
~~~
Replacing Halogen bulbs with F2 LED's ( ST1300 )
* Remove fairings
* Disconnect halogen bulb
* Remove rubber boot
* Open wire retaining bail and remove halogen bulb
* Separate the mounting base from the emitter and fan assembly of the F2
* Remove the lower 2 tabs from the mounting plate (ST1300; not sure about the 1100).
* Install the mounting plate and secure with the wire bail
* Reinstall the rubber boot
IMPORTANT: Install the boot BEFORE installing the emitter/fan assembly. I didn't do that on my first install because I didn't know that the base plate could be pulled off. That put the wire pigtail right against a hard plastic edge in the housing and after about 3,000 miles it had abraded to the point where a conductor was damaged and the light failed.
* Push LED emitters through center hole in boot and mounting plate; seat firmly and inspect from the front to ensure they are all the way through. The wiring pigtail coming off the fans should be at the bottom of the housing.
* Connect the wire pigtail from the bulb to the one from the power supply
* Connect power supply to OEM lighting harness using the stock 3-blade connector
Repeat on other side
(http://www.st-riders.net/aow/AOW%20-%20ST1300/F2%20LED%20Install%20-%20ST1300/Picture%201.jpg)
(http://www.st-riders.net/aow/AOW%20-%20ST1300/F2%20LED%20Install%20-%20ST1300/Picture%202.jpg)
(http://www.st-riders.net/aow/AOW%20-%20ST1300/F2%20LED%20Install%20-%20ST1300/Picture%203.jpg)
(http://www.st-riders.net/aow/AOW%20-%20ST1300/F2%20LED%20Install%20-%20ST1300/Picture%204.jpg)
(http://www.st-riders.net/aow/AOW%20-%20ST1300/F2%20LED%20Install%20-%20ST1300/Picture%205.jpg)
(http://www.st-riders.net/aow/AOW%20-%20ST1300/F2%20LED%20Install%20-%20ST1300/Picture%206.jpg)
(http://www.st-riders.net/aow/AOW%20-%20ST1300/F2%20LED%20Install%20-%20ST1300/Picture%207.jpg)
(http://www.st-riders.net/aow/AOW%20-%20ST1300/F2%20LED%20Install%20-%20ST1300/Picture%208.jpg)
* Power up and confirm proper aim, beam pattern, height. Adjust as needed. (Beam pattern is adjusted by rotating the emitters in the base.)
* Secure power supplies in convenient, not in the way locations
* Reinstall tupperware
* Go ride!
~~~
Thank You again for your contribution
Keith Adams, STOC #8824