Original article can be viewed here:
http://koczarski.com/ST1300/HeliRisers/Risers.htmWritten by by
Adam Koczarski, STOC #265:
~~~
Heli Bar® Risers ( ST1300 )
Remove these little caps off the four hex bolts.(http://koczarski.com/ST1300/HeliRisers/P0002809w.jpg)
After removing the 2 hex bolts and the one special bolt on each handle bar the bolt retaining the stock
riser will found when the bar is removed. I bought a 20" long 3/8" socket extension for the job but
didn't need it. If you turn the bars to full lock you can easily get a slightly offset 14mm closed end
wrench on the nut below. There's a washer under there too so be sure and grab it when you remove the nut!(http://koczarski.com/ST1300/HeliRisers/P0002811w.jpg)
Stock riser removed.
(http://koczarski.com/ST1300/HeliRisers/P0002813w.jpg)
Stock riser.(http://koczarski.com/ST1300/HeliRisers/P0002814w.jpg)
Heli Riser.(http://koczarski.com/ST1300/HeliRisers/P0002816w.jpg)
Heli riser in place and bars reattached.(http://koczarski.com/ST1300/HeliRisers/P0002817w.jpg)
Cover plate installed.(http://koczarski.com/ST1300/HeliRisers/P0002818w.jpg)
~~~
Thank You again for your contribution
Adam Koczarski, STOC #265