News:

Welcome to the liST! Before Posting,  READ the liST rules stickie post Here! This is a private, STOC-members-only forum. Your real name and STOC# must appear in all posts. Failure to comply with these rules may result in your profile being changed, your account being suspended and/or your posts being removed.

Main Menu

Tank Bag Hydration System (ST1100\ST1300)

Started by KoTAOW, May 06, 2009, 07:56:09 PM

Previous topic - Next topic

KoTAOW

Original text and photos here:
http://www.illzoni.com/bikes/farkles/tankbag/

Submitted by Jon Ransom


Tank Bag Hydration System


I got tired of everything in my tankbag sloshing around as I rode or carried it off the bike.  Most important of the contents is my digital camera when I take it along.  Also, I don't like wearing a CamelBak© backpack, so I decided to incorporate the bladder into my foam design.

The white foam is quite dense, almost like Styrofoam© and is almost 2-1/4" thick.
The gray foam is much softer and is just over 2-3/4" thick.

Cutting the foam was quite easy once I employed the correct tool--an electric carving knife!
My wife isn't real keen on receiving it as a gift...I don't get it.    ;)

I used the Marsee© Ultra Pocket QL Tank Bag 35L purchased from Sierra Trading Post for about $80:
http://www.sierratradingpost.com/p/,78114_Marsee-Ultra-Pocket-QL-Motorcycle-Tank-Bag-35L.html

~~~

Photo #1:
 
In case the bladder ever leaks, it goes on the lower level.  I also cut a path for the tube.

Photo #2:
 
For the next level, I managed to filet the white from into ~1" thick halves.

Photo #3:

Half stays intact as the barrier above the bladder, while the other half will serve as part of the upper level.

Photo #4:
 
From bottom to top...
The intact ~1" half; 
The other ~1" half with cutouts for my gear; 
Full thickness grey foam cut to match the upper white half.

Photo #5:
 
As shown...
The left slot holds the Zumo 550;
The camera spot is obvious;
The lower spot is for my prescription, reading, and sunglasses;
The rest just hold misc junk I carry.

Photo #6:

All of it stacked, including the lower/bladder layer.
It's far from perfect, as the bladder layer is a bit larger.

Photo #7:

All of it in the tankbag.

Photo #8:

Zips closed just fine with all of it in.

Photo #9:

Without the bladder layer, it sits lower and will accommodate even more misc junk.

Thanks Jon.