Author Topic: Heli BarŪ Risers ( ST1300 )  (Read 6529 times)

Offline KoTAOW

  • Keeper of the Archive of Wisdom
  • Moderator
  • STrider
  • *****
  • Posts: 465
Heli BarŪ Risers ( ST1300 )
« on: October 18, 2011, 05:49:03 PM »
Original article can be viewed here:
http://koczarski.com/ST1300/HeliRisers/Risers.htm

Written by by Adam Koczarski, STOC #265:

~~~

Heli BarŪ Risers ( ST1300 )

Remove these little caps off the four hex bolts.



After removing the 2 hex bolts and the one special bolt on each handle bar the bolt retaining the stock
riser will found when the bar is removed. I bought a 20" long 3/8" socket extension for the job but
didn't need it. If you turn the bars to full lock you can easily get a slightly offset 14mm closed end
wrench on the nut below. There's a washer under there too so be sure and grab it when you remove the nut!



Stock riser removed.


Stock riser.



Heli Riser.


Heli riser in place and bars reattached.



Cover plate installed.



~~~

Thank You again for your contribution Adam Koczarski, STOC #265
« Last Edit: October 19, 2011, 06:55:13 AM by KoTAOW »