News:

Welcome to the liST! Before Posting,  READ the liST rules stickie post Here! This is a private, STOC-members-only forum. Your real name and STOC# must appear in all posts. Failure to comply with these rules may result in your profile being changed, your account being suspended and/or your posts being removed.

Main Menu

Rear Wheel - The Elusive 3-rd O-ring ( ST1100 )

Started by KoTAOW, March 27, 2009, 09:21:32 PM

Previous topic - Next topic

KoTAOW

Rear Wheel - The Elusive 3rd O-ring

Original article on Mike Martin's web page here:  http://home.insightbb.com/~mmartin36/3rdOring.htm edit: http://koczarski.com/mmartin/3rdOring.htm

~~~

Every time the rear tire is changed, it is time to replace the three O-rings which keep the moly paste in place. Two of the O-rings are immediately found, but one is not so obvious.


Part number 91358-MG9-003 (50.5mm x 3.5mm) goes in a groove adjacent to the splines on the final driven flange.


Part number 91304-KT8-003 (61mm x 2mm) goes on the shoulder of the wheel. An alternate number is 91302-MA6-003. You will see this one when you pull the final driven flange off the wheel.


Part number 91356-MG9-003 (39.5mm x 2.4mm) is the elusive third one. It is found in the final drive, where the final driven flange splines mate up to the ring gear splines. In the picture, a small screwdriver is shown stretching the O-ring a bit out of its groove.


In case you need a reason to religiously replace the O-rings and lube the parts with Moly paste, here's what happened to Mike Sumner's splines. Contrast them with those in the first picture. $$$$$$$!

Now that you know where the O-rings go, here's the scoop on where the moly paste goes, per John O., "The Honda manual's a little confusing. Simply, the lube icon on the first Rear Wheel Removal/Installation schematic should be an "MP", not an "M". The 'Note' on the second page doesn't mention the percentage of moly, BTW. The remarks section on the 4th page specifically calls for moly *paste* all over the Final Driven Flange. Also, take a look at the Lube-n-Seal Pts section of chapter 1 in the Honda Service Manual for more info/confirmation.

"Only use moly *paste* with a Molybdenum Disulfide content of 40% or greater on all the rear wheel R&R parts... drive splines, thrust washer, etc. No puny 3% 'grease' STuff in this area.

"Recommend: Pro Honda Moly 60 Paste, PN: 08734-0001 / PASTE (MOLY 60) or this Loctite alternative, PN:51048 - Moly Paste [65%]"

Here's an illustration showing how much moly paste to use and where to use it. More approved materials are listed, too. http://koczarski.com/mmartin/drive_spline_lube_points.gif

Last updated on October22, 2007     © 2004 M. E. Martin, all rights reserved. edit: updated on 16 Apr 2015 by John OoSTerhuis, following Mike's ST1100 website content being moved.

Thank You again for your contribution Mike Martin